Technical support
Contact us for fast support for your YETI
Fill out the form or call us toll-free at 1-877-347-5521.
If the system has stopped, write down the message shown on the control panel display: it will help us troubleshoot faster.
Support request form
Describe the problem and our team will get back to you quickly
Documents to download
The user manual covers installation, the clearing cycle, the control panel, maintenance and troubleshooting. The other documents are for the electrician or technician who installs or repairs the system.
Technical support videos
I'm subtitle
YETI V3 installation, step by step
I'm subtitle
Photocell installation
I'm subtitle
Upgrade kit available
I'm subtitle
How to operate the YETI
Maintenance and troubleshooting
I'm subtitle
Seasonal maintenance
- During freeze-thaw periods: check that the anchoring spikes are holding firmly.
- Once a season: check that the brushes are securely fastened to the axle and check wear on the protective skis.
- Every season: check the oil level in the transfer cases (VG 220 synthetic PAO oil).
- Greasing: grease the grease fittings with low-temperature bearing grease.
- Brush: the bottom of the brush must be level with the protective skis, or slightly lower.
- Base: keep the system level. Adjust the feet one at a time and check them during the season.
- After heavy buildup or at the end of the day: lower the head in manual mode, lock out the main disconnect switch, clean, then turn the key back to “AUTO.”
See section 5 of the user manual for details.
I'm subtitle
Quick troubleshooting
- No entry light on: check the main switch, the power supply and the emergency stop. The PLC battery may also need replacing.
- Entry light stays red: switch to manual mode, raise the head, switch back to “AUTO” and press “Reset.”
- Head does not rise at the end of the cycle: snow is probably covering a sensor or reflector. Press the emergency stop, then clean them.
- Red rear lights and the head rises on its own: a motor was overloaded (ice, snow or driving too fast). Do a visual check and, if everything looks normal, press “Reset.”
- Red rear lights and the head does not rise: power was cut or a safety device tripped. Write down the message on the display and call us.
See section 6 of the user manual for details.
Safety: before cleaning, adjusting or repairing the system, lock it out at the main disconnect switch. Never touch the head while it is moving. For fuses, breakers and the control panel, contact the trained person in charge or call us.